Victorum Exhaust Air Heat Pump Installation Guide
69
Victorum Combi
Transporting the unit
Transport and Handling
The Victorum Combi unit is delivered fully
packaged and fixed to a wooden pallet base. Care
should be taken when transporting the cylinder
unit ensuring that the casing is not damaged by
impact.
At least two people should lift the cylinder to
prevent injuries. The cylinder must be stored in
a dry area and must never be dropped during
handling. Packaging should only be removed at
the installation location. This will help protect the
structure and the components. The cylinder must
be installed on a level floor with the required load
bearing capability.
Suitable Location
Care should be taken that there is a minimum distance in front of the unit for service and maintenance
works to be carried out. Enough access to allow maintenance of the valves should be considered. In
addition, the immersion heater is 400mm in length and this distance should be considered to allow
withdrawal for servicing if required.
Install the cylinder unit where it is not exposed
to water/excessive moisture. Particular attention
is needed if sitting in a garage or outbuilding
as the unit should be protected from frost. All
exposed pipework must be insulated. The unit
must be installed upright on a base capable of
supporting its weight when full (please see the
technical specification section for weights).
The cylinder unit must be transported in an upright position only.
100mm
400
mm
100
mm
Clearance
10 mm
