Getting Started –
35
Figure 11. SWS Test and Setup Wizard.
6. Once you have the optical link established between the SOM and the Control Module of the
receiver and the laser is scanning, run the Wizard by clicking on the Start button in the
bottom of the form.
7. For a new system, all the configuration steps are included in the standard SWS setup
package distributed on the CD-ROM.
When the steps above are completed including the SWS software installation, the PPI is ready
to be used for collecting data from the receiver.
Should there be any difficulty installing, configuring or running the PPI, please refer to the
troubleshooting guide on the
Parallel Port Interface Troubleshooting
.
If the data acquisition board is used instead of the PPI, see the
Installing the Data Acquisition
Board
section for installation instructions.
Installing Additional Receiver Chassis
Up to eight chassis can be used for each receiver station. Each chassis holds eight detector
modules; therefore, up to 128 channels can be measured at a time ( or 126 if DBSSM installed).
The units are connected in a daisy-chain configuration using the top two 50-pin connectors at the
back of each chassis.
To add an additional receiver chassis and connect it to an existing chassis:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
