Getting Started –
31
Figure 7: Receiver Rear Setup
If there is more than one receiver chassis, use the following instructions to install the first
chassis. To add additional chassis, see the
Installing Additional Receiver Chassis
section.
Caution
The detector modules are not hot swappable. Turn the power off before
installing or removing a detector module.
To assemble the receiver:
1. Place the chassis on a solid surface near the user-supplied computer. The unit is also rack-
mountable (48.26 cm or 19 in wide rack). If rack mounting the chassis, use angle brackets
(user-supplied) on the bottom of the unit, in addition to the front screws. Ensure there is
sufficient clearance (10 cm front, 8 cm rear) for air intake and exhaust.
2. Insert the control module into the first slot, on the front left side of the chassis, and fasten it
using the screw fasteners.
3. Insert the detector module into the next slot and fasten it tightly using the screw fasteners to
ensure proper grounding of the detector module. If there are more detector modules, wait
before installing them; see the
Installing Additional Detector Modules
section for detailed
instruction.
At the back of the chassis, attach one end of the short 50-pin termination cable into the
Termination connector (bottom port) and the other end into the Additional Chassis connector
(middle port), also at the back of the chassis.
Using the Dual Band Selector Switch Module (DBSSM) with the SWS
The Dual Band Switch Selector Module (DBSSM) is an add-on component to the Swept
Wavelength System (SWS). It enables switching between two transmitters, so that data can be
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
