36 – Getting Started
1. Turn off the power at the back of all existing receiver chassis. The units do not need to be
unplugged.
2. Find the DIP switch on the back of the chassis. It should look like one of the following
Figure 12. Black DIP switches on older
versions of chassis
Figure 13. Red DIP switches on newer
chassis.
3. Set the DIP switch at the back of the new chassis to the next available address (Figure 14).
Figure 14: Additional Chassis DIP Switch Setup
4. As shown in Figure 15, remove the short termination cable from the middle and bottom 50-
pin connectors (Additional Chassis and Termination ports) at the back of the last chassis in
the set. Connect the jumper to the same connectors on the new chassis. For example, take
the jumper from the fourth chassis and connect it to the fifth chassis.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
