Jands HOG 1000, Operating Manual

Page: 29 / 126

Quick Start
••••
23
Sets the intensity at 100%. It’s not necessary to press
ENTER
after
Full
, it enters
automatically.
Sets an intensity level or a patch location: VL5 6 @ 40 .
Used for split fade times and sometimes fixture and cuelist selection: Time 5 / 7 .
Subtracts one item from a series: fixture
1 Thru 10 - 5
.
Completes an operation.
The four buttons above the keypad— Group , Position , Colour , and Beam —are used to select specific
groups or palettes (like group number 19).
Adjusting Parameters
Setting Intensity
Select Desk Channels as above, then
•
Move the left parameter wheel. The labels above the wheels indicate what the wheels control and their
current setting.
OR:
•
Press Full to set to 100%.
OR:
•
Press @65 ENTER . It is possible to skip the last digit for levels ending in zero. For example, @ 6
ENTER sets the fixtures to 60%. For 6%, type @ 06 ENTER .
Further selections can then be made and intensities set for other fixtures.
Intensities can also be set using the toolbar functions
+10%, -10%, Out
, and
Rem Dim
.
+10%
and
–10%
adjust the intensity up or down by 10%, Out brings the intensity of all selected fixtures to
0%, and Rem Dim brings the intensity of all fixtures in the programmer that aren’t selected to 0%.
We will see how to change other parameter types later on in this chapter.
Blind
If you don’t want the programmer to output its contents, press Blind . The Blind LED illuminates until the
button is pressed again, when the programmer returns to normal.
Programmer Contents Display
The easiest way to keep track of what’s actually in the programmer is to use the Programmer Contents
window. Open it by holding the
Monitor and pressing
Progrm
on the toolbar.