Jands HOG 1000, Operating Manual

Page: 18 / 126

12
••••
HOG – Version 3.20
Patch the Miniscan hpe @ 30.
When you’re done, the patch list window will look similar to the one shown.
Clearing Fixtures from the Patch
To eliminate fixtures from the patch:
1
Select the fixtures - just as if you were going to patch them, but
do not press the
ENTER
button.
2
Select the output you want to clear them from.
3
Press
Unpatch
on the bottom toolbar. This will remove the
chosen fixtures from the selected output.
To clear an entire output, select the desired output to clear, press
Unpatch
while no fixtures are selected
(ie, after you’ve pressed the programmer
clear restore
button). The console will ask for verification.
Press
Okay
to finish.
Note: Parameters from unpatched fixtures will not be executed by masters. Thus a cue with
entirely unpatched fixtures will have no affect on the state of a master’s LEDs (ie they will
not turn on). In addition, unpatched parameters will be shown on the Output window as
Unpatched .
Auto Menus
It’s a good idea to use the Auto Menu function to set up standard palettes for the fixtures to be used. While
these palettes may not cover all your needs, they’ll give you a good base to start with. It’s best to only set
up the Auto Menus once, after you have patched all the fixtures that you are likely to use. While in the
patch screen press the
Auto Menu
toolbar to bring up the Auto Menus window.
To generate auto menus, press
Generate
on the toolbar. If you wish to reset the options in the auto menus
window, press
Reset All
.