Iwatsu DS-8814, Operation Manual

Page: 93 / 141

74
Copy to floppy disk
1. Select Copy in the UTILITIES menu and display the copy menu.
2. Through [FUNCTION operation], set Device to Floppy.
3. Through [FUNCTION operation], set Type to TIFF (or BMP).
4. Through [FUNCTION operation], set Function to Copy.
5. Through [FUNCTION operation], set File No. at every step
(e.g."1"). If Coarse is selected, File No.can be set at every 10
steps.
6. After file No. is selected, press the FUNCTION knob to confirm
the setting. Every depressing of the Copy button executes a copy
and increments file No. by 1 when the copy is completed.
Copy to ATA card
1. Select Copy in the UTILITIES menu and display the copy menu.
2. Through [FUNCTION operation], set Device to ATA Card.
Subsequently, perform the same operation steps 3 to 6 as
described for copying to floppy disk.
If Coarse is selected for ATA card, File No. can be set at every 20
steps.
Selecting Delete in the Function menu allows a specified file to be
deleted.
Auto Copy makes a copy to a specified device every new waveform is
acquired automatically.
Turning On Auto Copy stops waveform acquisition and pressing the
RUN/STOP button restarts waveform acquisition.
No operation other than RUN/STOP button operation is accepted while
Auto Copy is in progress. While operation is stopped, the Auto Copy
setting is turned Off.
Deleting file
Setting
Auto Copy
Number of files and capacity
A floppy disk can save up to 200 TIFF or BMP files.
An ATA card can save up to 9999 TIFF or BMP files.
Each file requires a capacity of 10 Kbytes, but the number of files that can be
saved depends on the remaining capacity of a floppy disk or ATA card.