Iwatsu DS-8814, Operation Manual

Page: 98 / 141

79
Trace selection
VOLT/DIV
Zoom
Coupling
Offset
Offset setting
Probe ratio
Band Width
Sweep Mode
Trig Type
Source
Coupling
Slope
Level
Holdoff
TIME/DIV
Delay
Mode
Equ Smpl
Roll
Persist
Length
Join
Type
Math
REF waveform
CH1 to CH4: Do not change the setting.
When frequency is 50 Hz to 50 MHz
2 mV to 10 V/div and amplitude approx. 2 to 7 div
Off
DC or AC
1 CH is displayed.: Near 0 div from center of
screen.
2 CHs are displayed.: Near +2 div and –2 div from
center of screen.
3 CHs are displayed.: Near +3 div, +1 div, -1 div, and
-3 div from center of screen.
4 CHs are displayed.: Near +3 div, +1 div, -1 div, and
-3 div from center of screen.
Division
Auto
Off
Auto
Edge
Keeps the settings before execution. However, when
the channel of the trigger source is off, the On channel
is detected from the smallest channel No.
DC
Pos
Near center of waveform
Off
10 ms to 5 ns/div
Approx. 2.5 to 5 periods of signal
0.00
Norm Smpl
Depends on TIME/DIV setting.
Do not change the setting.
Off
Do not change the setting.
Do not change the setting.
YT
This setting is set to off for Add/Sub/Multi. YT is
displayed with the setting kept for FFT.
Do not change the setting.
VERTICAL
TRIGGER
HORIZONTAL
ACQUISITION
DISPLAY
Others
Appendix 3
AUTOSET measuring conditions