Iwatsu DS-8814, Operation Manual

Page: 89 / 141

70
Save/recall/delete (SAVE/RECALL/DELETE)
Also see Section 1 "SAVE/RECALL menu" (pages 36 to 39).
Selecting DEVICE in the SAVE/RECALL menu shows the remaining
capacity of a medium.
Capacity
display
While Floppy or ATA Card is highlighted, the remaining
capacity of the medium is displayed at the bottom of
the screen.
Saving panel setting to ATA card
1. Display SAVE/RECALL menu.
2. Through [FUNCTION operation], set Device to ATA card.
3. Through [FUNCTION operation], set Type to Setup (panel
setting).
4. Set Function to Save with [Function operation].
5. Specify the File No. (e.g. specify "1").
You can set the file No. in steps of 20 when Course is set.
6. After specifying the File No., press the FUNCTION knob. The
message "Press FUNCTION to save" appears. Press the knob
again to execute SAVE. If the specified file already exists, the
message "Press FUNCTION again to overwrite" appears.
Recalling panel setting from ATA card
1 to 3. Perform the same setting as that for saving.
4. Through [FUNCTION operation], set Function to Recall (recall).
5. Specify the File No. (e.g. specify "1"). Only existing file Nos. are
selected and displayed during a recall. If Coarse is selected, the
existing files are selected and displayed at every 20 steps. If no
files are found, **** is displayed. When recalling the panel setting
from an ATA card, selected file Nos. are recalled sequentially.
6. Pressing the FUNCTION knob stops the recall.