Iwatsu DS-8814, Operation Manual

Page: 44 / 141

25
Attachment procedure
Built-in printer
Pressing the Copy button for 1 second or more starts paper
feed when the built-in printer is used. The paper feed stops
when the button is released.
(Pressing this button for less than 1 sec simply performs
normal copy operation.)
Paper feed
Paper holding lever
Slide
Handle
Open
the
cover
Paper holding
lever
Slide
Cut the roll paper end straight, and pull out the
paper end by about 10cm.
Put the paper on the cover between the paper
guides. Set the holding lever to the center position
(lease) from the rear side position (lock).
Insert the paper end beneath the roller until the
paper is fed about 15 seconds automatically.
Loading printer roll paper
Turn on the power of the scope.
Pull up the handle. Unlock the slide button on the
printer cover toward the rear.
Open the cover.
Move the paper from the cover to the paper holder.
Rewind the roll paper slightly to straighten the
paper. Set the paper holding lever toward the rear
to lock it.
Be sure to raise the handle before opening
the cover.
Attention
Attention
Printing is not possible if the paper holding
lever is set to the Release position at the
center.
Insert the paper end into the hole of the cover, and
then close the cover.
Lock the slide button on the printer cover toward
the front (lock).