Iwatsu DS-8814, Operation Manual

Page: 3 / 141

iii
Installation
• Do not use in an environment with explosive gases. It may cause an explosion.
• If you notice smoke, foul odor or abnormal noise, immediately stop measuring
to avoid electric shock or fire. Turn off the instrument to be measured and
disconnect the power cable from the power outlet. Please contact our Homepage
listed at the end of this manual or our sales distributor. Do not attempt to repair
the unit yourself.
Power Supply
• Always use this instrument only within the rated operating voltage. If used over
the rated range, electric shock, fire or failure may occur. The range of operating
voltage is stated on the rear panel.
This instrument runs on single-phase, 115 V (90 to 132 V) or 220 V (180 to 250
V), AC power source at 45 to 66 Hz. No voltage selection is required, as the
instrument automatically adapts to the line voltage.
• Use a 3-prong grounded power cord. By connecting the attached 3-prong power
cord to a 3-wire receptacle, the grounding wire of the power cord is connected
to ground. If this is not done, an electric shock or instrument damage could
result. When supplying power from a 2-wire receptacle using a 3-prong/2-prong
conversion adapter, connect the grounding terminal of the 3-prong/2-prong
conversion adapter to ground.
• Use of a 2-prong power cord may result in electric shock.
If the supply voltage is of a 200 V system (200 V to 240 V), use a 200 V system
(rated 250 V) 3-prong power cord.
Read the following safety information.
Warnings