Goodrive3000 series medium voltage VFD
HMI
-19-
4.2.2 Displaying running-state parameters
PRG
ESC
DATA
ENT
SHIFT
RUN
STOP
RST
QUICK
JOG
FWD running
Running frequency:
Set frequency:
Bus voltage:
50.00Hz
50.00Hz
950V
After receiving a valid running command, the VFD enters the
running state, and the keypad displays running-state parameters,
with the RUN/TUNE indicator on. The on/off state of the FWD/REV
indicator is determined by the actual running direction. See the
figure.
In the running state, various kinds of parameters can be displayed.
You can determine which parameters are displayed by setting the
binary bits of P07.05, P07.05. For definitions of the bits, see the
description of P07.05 in Chapter 5 and the description of P07.05
and P07.06 in Chapter 6.
You can press
》
/SHIFT to shift selected parameters from left to
right or press QUICK/JOG to shift selected parameters from right
to left.
4.2.3 Displaying fault information
PRG
ESC
DATA
ENT
SHIFT
RUN
STOP
RST
QUICK
JOG
In fault
Fault code: 23
23: Braking unit fault (bCE)
After detecting a fault signal, the VFD enters the fault alarm state
immediately, and the keypad displays fault information. The TRIP
indicator on the keypad is on. You can perform fault reset by using
the STOP/RST key, control terminals, or communication
commands.
If the fault persists, the fault code is continuously displayed.
4.2.4 Keypad setting and function menu selection
Press and hold the SHIFT and DOWN keys for 3 seconds when the keypad is powered on. The keypad then enters the
function menu selection mode.
1. Hardware test: used to check the keys, displays and indicators.
2. Flash date program: used only when the FLASH configuration table is updated.
3. Language select: used to select the language (English).
4. Keypad SW ver: used to check the MCU and Flash software versions.
5. Converter Type Select: VFD series selection. Option 1: GD3000; Other: reserved.
Goodrive3000 series English mode is selected by default.
4.2.5 Editing function codes
You can press the PRG/ESC key to enter the editing mode in stopped, running, or fault alarm state (if a user password is
used, see the description of P07.00 for both VFD rectifier and inverter). You can press the DATA/ENT key to enter the
function parameter display interface. In the function parameter display interface, you can press the DATA/ENT key to save
parameter settings or press the PRG/ESC key to exit the parameter display interface.
