S R A / S F X 2 1 0 0 S E R I E S S A T E L L I T E R E C E I V E R
69
Edit Field
Description
on the multicast packet being routed. The following selections
are available:
ACCEPT_PACKET – accept packet and output according to
Interface above.
DISCARD_PACKET – throw away the packet.
PASS_TO_IGMP – pass the packet on to for processing by the
IGMP function, before being output on the Interface above.
Figure 4-22 Edit Multicast Routing Table Page
The following fields can be edited on the Edit Multicast Routing Table page:
Edit Field
Description
Interfaces
This drop down box selects the network interface that will be the
destination of the routed multicast IP packets. This selection
allows you to specify exactly where the multicast packets should
be output. The selections available are the same as the
Interface in the Edit Default Route.
!
Clicking on the “not” (!) check box negates the logic for the
immediate edit field to the right of the check box. For example, !
224.1.1.1 for the Source IP would mean all IP addresses whose
source IP address is not 224.1.1.1.
SourceIP
Enter a source IP Address in dotted decimal notation, here if you
wish. “Any” is implied if no Source IP is entered.
NOTE
:
The
SourceIP fields
are optional,
and “Any” is
the implied
default value.
NOTE
:
There
are limitations
to the selection
combinations
of Interface and
Action: “ALL”
cannot be used
with “ACCEPT
PACKET”, but
must be used
for “DISCARD
PACKET” and
“PASS TO
IGMP”. If
“PASS TO
IGMP” is used,
make sure
IGMP is
enabled on the
appropriate
network
interface(s).
