S R A / S F X 2 1 0 0 S E R I E S S A T E L L I T E R E C E I V E R
25
-c
Sets the speed and duplex of the Ethernet port. Allowable values are:
•
10h – 10 Mbps, half duplex
•
10f – 10 Mbps, full duplex
•
100h – 100 Mbps, half duplex
•
100f – 100 Mbps, full duplex
•
auto – autonegotiate speed and duplex
Normally, interfaces should be set to autonegotiate. If
-c
is not specified, this
command displays the current settings of the selected Ethernet interface.
-i
Specifies the Ethernet interface to apply this command. The <interface> name
must be either "eth0" or "eth1".
-h
Displays a usage message.
-m
Causes
configeth
to display its output in a machine friendly (rather than a human-
friendly format). This option is not generally used by interactive users.
RestoreFactorySettings
Usage:
RestoreFactorySettings
RestoreFactorySettings is only available to the
admin
user and only on the SRA2100 family
of receivers.
This command resets all configuration items that can be manipulated by the "Set"
commands described in this section back to their defaults. This command should be used
with extreme caution as it will cause satellite carrier settings and IP addresses to be lost.
The host must be rebooted immediately after this command is issued. This command takes
no parameters.
SetPassword
Usage:
SetPassword
This command changes the password of the account that is currently logged in. When this
command is run, the user is prompted to enter the new password twice. Passwords that are
too simple will be rejected.
Ping
Usage:
ping <host>
