17
Incorrect programming:
Fast beep sequence.
2.3 Resetting your PABX
During reset your PABX assume the initial configuration. In case of total reset you
PABX will also reset the control buffers and the circuits. This should be your last
alternative to resolve a specific problem, or when you want your PABX to use
factory default setting after having been altered.
Total reset
(delete stored logs in memory)
Lift handset, enter
+
MAIN PASSWORD
(3 digits), wait for
confirmation tone. Unplug the power supply wire, wait for 30 seconds and then
switch on the PABX.
Partial reset
(Do not delete stored logs in memory)
Lift handset, enter
+
MAIN PASSWORD
(3 digits), wait for
confirmation tone. Unplug the power supply wire and wait for 30 seconds and then
switch on the PABX.
2.4 Configuring the lines as route 0
Factory settings : This PABX is set to function in DTMF mode (multifrequencial),
receiving and making calls through route 0.
This program feature will define the signaling mode used by the PABX. You can
also block a line or transform it into an internal enlace.
How to indetify your telephone line signal
- Before connecting your external line to the PABX make sure to identify the line
signaling type (Pulse or Tone). To do so, establish a call using a regular
telephone connected to the telephone line in mode
Tone:
- If the call is established, your line has a multifrequencial signal (Tone). In such
case, you can use your PABX without any configuration programmimg of the
line as route 0 since the PABX comes programmed to operate in
multifrequencial mode (Tone)
- If the call is not established, this means that your line has a decadic (Pulse)
signal. In such case, try to inquire with your carrier about the possibility to alter
your line signal to multifrequencial. If not, you will need to configure your lines
as route 0 to program your PABX
If the PABX has the
communication
board, the internal
calendar should be
set again.
This function is
carried out from
the main extension
not in programming
mode, lift the
handset and
execute the
command.
