25
tone.
Setting the PABX to remain without overflow auto-answer
Lift handset, press
+
MAIN PA
+
LINE +
, wait for confirmation tone.
If the line is programmed without overflow auto-answer and the main extension (operator) was in
program setting, the incoming call will be forwarded to nightmode auto-answer. If the line is set
without overflow auto-answer, you need to make sure to set the overflow time different from
zero, otherwise, the calls will be dropped.
Example: You want to set extension 23 as overflow operator for line 1: Enter in PABX programming
mode and press 4 + 1 + 2 + 23.
2.10.5 Setting overflow time for line or night mode operator
Factory setting: 35 seconds
.
Setting overflow time
Lift handset, press
+
MAIN PA
+
LINE +
+ TIME (00 to 80 seconds),
wait for confirmation tone.
Example: You want all incoming calls ringing for 70 seconds on the extension operator before
diverting the call: Enter in PABX program mode and press 4 + 9 + 4 + 70.
2.10.6 Ring overflow for night mode
Factory setting: Activated.
Desactivating ring overflow for night mode
Lift handset, press
+
MAIN PASSWORD +
+
LINE +
, wait for confirmation
tone.
Activating ring overflow for night mode
Lift handset, press
+
MAIN PA
+
LINE +
, wait for confirmation
tone.
Example 1: to remove ring overflow for incoming calls through line 1 during nightmode, enter in
PABX program mode and press 4 + 1 + 870.
Example 2: to program all lines without ring overflow for incloming calls in night mode , entre enter
in PABX program mode and press 4 + 9 + 870.
2.11 Identifying incoming calls
Factory setting: Ringing time equals zero, all calls will be forwarded to PABX operator.
This feature allows you to determine the ringing time before ringing on the operator extension.
OBS.:
For Call ID showings category, internal calls are presented as follows: 9 + extension
