19
various lines can be programmed for the same route.
When you enter the line access code through route 0 (external call, private code,
phonebook, doorphone, emergency call), the PABX will wait for the intial dialing to
select the corresponding route.
Lift handset, press
+
MAIN PASSWORD (3 digits) +
+
ROUTE
(1 to 3)
+
CALL CATEGORY
(0 to 5)
, wait for confirmation tone.
CALL CATEGORY
0 cancel line selection
1 IDD (International Direct Dial)
2 DDD (Domestic Direct Dial)
3 local
4cellular local
5 cellular DDD
Important:
- The route(s) used in this programming can not be by the extensions with access
code to special route;
- There should be at least one line programmed as selected route ( see
configurating lines, in this manual);
- It is possible to program more than one call category for the same route.
2.6 Extension Number Setting
Factory setting: physical position from 00 to 11 and extension numbering from 20 to 31
.
This a table that associates the number of each extension with its physical position
(PABX extension connectors). The physical position is not flexible while the
extension numbering varies as per necessity.
Altering the extension number setting
Lift handset, press
+
MAIN PASSWORD (3 digits) +
+
PHYSICAL
POSITION
(00 to 11)
+
Nº OF EXTENSION, wait for tone confirmation.
Example 1: You are a hotel owner and want the extension numbers to match the
room numbers. Room 201 connected to position 01, the extension number will be
201, press 51 + 01 + 201, follow the same procedure to assign the remaining
numbers with other extensions.
Example 2: Your PABX has extension 21 and 22 occupying repectively position 01
and 02, and you want to invert the numbers, perform the following:
- Free extension 22 from its physical position (02) to assign it another position, press
51 + 02 + an inexistant extension (with programmable number);
- Press 51 + 01 + 22, assigning extension 22 the position 01;
- Press 51 + 01 + 21, assigning extension 21 the position 02.
Extension number
can be set from 20
to 39 or from 200
to 2999 (always
starting with 2).
If the extension
number setting is
altered after
programming your
extensions, you
need to reprogram
the extensions.
