11
1.8.2 Installing line 3 and 4
To install line 3 and 4, you need 2 trunk boards. The following instructions will guide you through the process
of installation:
1.8.2.1 Installing the trunk boards for line 3 (Conecta) and 3 and 4 (Modulare i).
Unsheath the wire end (line 3 & 4) and
press down the conector´s crank (CN 40)
Insert the wires
and release the
crank.
Line 3:
Remove jumper CN 32 and install the trunk
board in the slots CN20; CN30; CN 32 e
CN33. If after installing the board, line 3 is not
used, you should open the jumper J1 of the
board.
Line 4:
Remove jumper CN 34 and install the trunk
board in the slots CN21, CN31, CN 34 and
CN35. If after installing the board, line 3 is not
used, you should open the jumper J1 of the
board.
