![background image](http://html1.mh-extra.com/html/insportline/em-3231/em-3231_user-manual_2068958016.webp)
STEP 10
– UPPER HANDLEBAR ASSEMBLY
USE HARDWARE KIT
C
a.
There is an “L” decal on the
Left Upper
Handlebar (6)
, and a “R” decal on the
Right
Upper Handlebar (7)
b. Insert the
Right Handlebar (7)
into the
Right
Pivoting Arm (9)
and secure with two
Bolts,
Socket Head (M6xp1.0x35mm)(102)
and two
Nut (M6)(108)
NOTE:
Handlebar Sleeve (37)
has been pre-assembled
to the
Left & Right Upper Handlebar (6,7)
Notice that
Bolts (102)
’s assembly direction
should be the same as the above illustration
shown to avoid the bolts couldn’t tighten the
handlebar completely
c. Slide the
Handlebar Sleeve (37)
down to
cover the bolts on the
Right Handlebar (7)
d. Repeat the above assembly process on the
left side
Finish the assembly, make sure that all parts
are tightened before you use the equipment
STEP 11
– AC ADAPTOR
a. Connect the
Adaptor (117)
to the connector located on the front side of the
Main Frame (1)
b. Plug the
Adaptor (117)
into an electrical outlet to light up the console
OPERATION INSTRUCTIONS
HOW TO ADJUST THE ADJUSTING END CAPS OF THE REAR STABILIZER
a. After placing the equipment in the intended location for use, check the stability of the equipment
b.
If it’s the one of the
Adjusting EndCaps (24)
on rear end of the
Rear Stabilizer (3)
causes a slight
rocking motion. To level the equipment, turn one or both of the
Adjusting EndCaps (24)
in
clockwise or counter-clockwise direction until the equipment sets on the floor without rocking
Summary of Contents for EM-3231
Page 7: ...108 Nut M6 4 pcs...
Page 48: ...PRODUCT PARTS DRAWING A...
Page 49: ...PRODUCT PARTS DRAWING B...