Insportline EM-3231, User Manual

Page: 11 / 55

STEP 3
– PEDAL LINKAGE TUBE ASSEMBLY
USE HARDWARE KIT B
* Do not cut off the tie (53A) until point b. of STEP 3
* Please be sure that Bolt (98) would screw through the
Shaft Sleeve (69) inside the front end of the Right Pedal
Linkage Tube (53) and Right Pivoting Arm (9) during
assembly
a. Attach the rear end of the Right
Pedal Linkage Tube (53) on the top
of the Right Pedal Suspension
Stand (65) and slightly attach with
one Bolt, Button Head
(M10xp1.25x50mm)(83) and one Nut
(M10)(111). NOTE: Please notice that
do not fully tighten Bolt (83) & Nut
(111) and wait until point d of Step 3.
to fully tighten, and also notice that
the
Right Pedal Suspension Stand
(65)
’s accurate assembly direction
should face backward as the
illustration shows on the left .
b. Refer to the inset drawing FIG .1 , cut
off the tie (53A). NOTE: Please be
sure the Shaft Sleeve (69)
won’t fall
out from the front of the Right Pedal
Linkage Tube (53).
c. Attach the front end of the Right
Pedal Linkage Tube (53) to the
Right Pivoting Arm (9) and fully
secure with one Bolt, Button Head
(M8xp1.25x90mm)(98) and one Nut
(M8)(109). NOTE: Please be sure that
Bolt (98) would screw through the
Shaft Sleeve (69) inside front end of
the Right Pedal Linkage Tube (53)
during assembly.
d. Go back to step a. to fully tighten Bolt
(83) and Nut (111) .
e. Repeat the above assembly process
on the left side.