Optic 6 Sport - Page 36
This section covers the Optic 6 Sport programming that is specific to the HELI mode for flying a model Helicopter.
To avoid duplication of text within the manual we suggest that if you have not already read the following you refer to this previously
shown information in the front of the manual.
- Introducing the Optic Sport
- If you are new to Computerized RC Transmitters
- Charging the Batteries
- Flying Safely
- Mode 1 Configuration
- Flying Field info
- Frequency Control
- Optic sport Programming Switches and Buttons
- Initial Setup Menu Programming
- Transmitter Displays and Messages
Please note: To reference all other Optic 6 Sport programming instructions not specific to the HELI menu refer to the Initial Setup
menu on page 13 and the ACRO Model Setup menu starting on page 17.
Optic 6 Sport Manual for Helicopters
Optic 6 Sport Heli In-Flight Controls
This figure shows the assignments for a Mode 2 system as supplied by the factory.
Note that some of the functions will not operate until activated in the mixing menus.
Trainer or
engine Cut
Switch
SW 2
Roll
Pitch
Tailrotor
Dual and
Exponential
Rate Switch
SW 1
Throttle Hold Switch
Tail Rotor
and Throttle/
Collective Stick
Pitch and Roll
Stick Stick
Throttle
Trim Switch
Pitch Trim
Switch
Tail Rotor
Trim Switch
Roll Trim
Switch
Power Switch
SW 3
NOR,
Idle-Up 1 & 2 Switch
EDIT
DATA
CURSOR
TIMER RESET
TIMER MODE
TIMER START
LOCK
CLEAR
6 CHANNEL DIGITAL PROPORTIONAL
FM RADIO CONTROL SYSTEM
