Optic 6 Sport - Page 12
Timer
If you push either DATA button, you will enable the radio's timer
mode.
The word "TIMER" appears on the screen as well as a number
indicating the starting countdown time (which you can set in the
Initial Setup menu). If you push the right hand CURSOR button,
the timer will start counting down and the numbers will diminish in
one-second increments. Push it again and the countdown stops.
Pushing the left hand CURSOR button resets the timer.
Lock Indicator Screen
When you push the Lock button to hold the throttle at an idle,
the word "LOCK" appears in a black box above the voltage value.
When you push the lock button again, this symbol disappears to
indicate that you have disabled the function.
Receiver-Servo Connection List
Transmitter Displays and Messages
The table below shows where the aircraft's servos should plug into a six-channel receiver. Note that some functions shown will not operate
until they are activated in the transmitter. The standard function is listed first for each channel.
When you first turn on your transmitter, the first screen shown
below appears on the LCD display. Before flying, or even starting
the engine,
BE SURE that the model number appearing next to the voltage
matches the model that you are about to fly! If you don't, reversed
servos and incorrect trims will lead to an immediate crash.
If you press timer or engine cut or lock keys, you go directly to
those functions regardless of the display.
This screen appears whenever you turn on the transmitter without
pushing any other buttons.
The model number currently enabled is the small number just to
the right of the battery voltage and the programming baseline for
this model (ACRO, GLID or HELI) is shown in the upper left hand
corner.
In the center bottom of the screen "NOR" appears in a small black
box indicating that the transmitter is in the "Normal" flight mode
condition.
Startup Screen
Rx. Ch.
ACRO
GLID
HELI
Aileron
Aileron
Roll Cyclic
One
or Right Flaperon (FLPN ON)
or Right Aileron (ADIF on)
or Swash servo 1 (120¡Æ)
or Right Elevon
Elevator
Elevator
Pitch Cyclic
Two
or Right V tail (VTAL on)
or Right V tail (VTAL on)
or Swash servo 2 (120¡Æ)
or Left Elevon (ELVN on)
Three
Throttle
Throttle
Throttle
Four
Rudder
Rudder
Tail Rotor
or Left V tail (VTAL on)
or Left V tail (VTAL on)
Five
Landing Gear
Left Aileron (ADIF on)
Gyro Gain
Six
Flap
Flap
Collective
or Left Aileron (FLPN on)
or Swash Servo 3 (120¡Æ)
