![background image](http://html1.mh-extra.com/html/ifm/ecomat-300-ac1318/ecomat-300-ac1318_supplementary-device-manual_3919725016.webp)
ifm
Supplementary device manual DeviceNet interface in the AS-i ControllerE (AC1318, AC1324), Target from 15
2012-02-29
Getting started
General setup
16
4.2 General
setup
1506
START
END
Address AS-i slaves automatically
during assembling?
Install Hardware:
Power supplies, AS-i network, preaddressed
slaves, optional accessories (repeater, tuner etc.)
Switch on power supplies (24 V und AS-i)
Switch ControllerE into "Easy startup" mode: [Menu] >
[Address Slaves] > [Easy Startup] > [AS-i Master x]
Connect all AS-i slaves with address 0 one after
another to the AS-i bus
Check state of things (1)
LED [24 V PWR] = green continuous light!
LED [PWR / COM] = green continuous light!
LED [PLC RUN] = yellow continuous light!
Check slave lists:
[Menu] > [Slave Lists] > [AS-i Master x] >
[Detected Slaves]
yes
no
yes
no
yes
no
Are all state of the things okay?
Are all state of the things okay?
Setup the AS-i projection:
Current state is to be saved as target state:
[Menu] > [Quick Setup] > [Config. all]
Check state of things (2)
LED [CONF / PF] = out!
LED [PROJ] = out!
Check slave lists:
[Menu] > [Slave Lists] > [AS-i Master x] >
[Projected Slaves]
Address AS-i slaves via addressing unit
(e.g. AC1144)
Install Hardware:
Power supplies, AS-i network, preaddressed
slaves, optional accessories (repeater, tuner etc.)
Switch on power supplies (24 V und AS-i)
Troubleshooting (1)
Troubleshooting (2)