Important Safeguards and Warnings
Electrical Safety
●
All installation and operation shall conform to your local electrical safety codes.
●
The power supply must conform to the requirements of ES1 in IEC 62368-1 standard
and be no higher than PS2. Note that the power supply requirements are subject to
the device label.
●
Make sure that the power supply is correct before operating the device.
●
A readily accessible disconnecting device shall be incorporated in the building installation
wiring.
●
Prevent the power cable from being trampled or pressed, especially the plug, power
socket and the junction box.
Environment
●
Do not aim the device at strong light to focus, such as lamp light and sun light;
otherwise, it may cause over brightness or light marks, which are not device
malfunctions, and affect the longevity of Complementary Metal-Oxide Semiconductor
(CMOS).
●
Do not place the device in a damp, dusty extremely hot or cold environment, or
locations with strong electromagnetic radiation or unstable lighting.
●
Keep the device away from any liquid to avoid damage to the internal components.
●
Keep the indoor device away from rain or damp to avoid fire or lightning.
●
Keep sound ventilation to avoid heat accumulation.
●
Transport, use and store the device within the range of allowed humidity and temperature.
●
Heavy stress, violent vibration or water splash are not allowed during transportation,
storage and installation.
●
Pack the device with standard factory packaging or the equivalent material when
transporting the device.
●
Install the device in a location where only the professional staff with relevant
knowledge of safety guards and warnings can access it. The accidental injury may
happen to the
non-professionals who enter the installation area when the device is operating normally.
Operation and Daily Maintenance
●
Do not touch the heat dissipation component of the device to avoid scald.
●
Carefully follow the instructions in the manual when disassembling the device;
otherwise, it may cause water leakage or poor image quality due to unprofessional
operations. Make sure that the gasket ring is flat and properly installed in the groove
before installing the cover. Contact after-sales service for desiccant replacement if
there is condensed fog on the lens after unpacking or when the desiccant turns green
(Not all models are included with the desiccant).
●
We recommend using the device together with a lightning arrester to improve
III
