Icom MarineComander MXS-5000, Instruction Manual

Page: 59 / 194

2-43
2
PLOTTER OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Chart Setup
■
(MENU
w
Chart Setup)
• Perspective View – Mode
(MENU w Chart Setup u Perspective View u Mode)
• OFF : The Perspective View function is OFF.
• ON : The plotter screen is shown from the speci -
fied angle view.
To set the angle data for this function, see ‘Perspective
View Angle setting’ as described below.
Perspective View D
(MENU w Chart Setup u Perspective View)
When the Perspective View function is ON, you can
see the plotter screen from the specified angle view. If
this function is OFF, the map is shown from the 90-de-
gree.
Push [MENU], then rotate [DIAL] until the “Chart
q
Setup” menu is highlighted, then push [ENTER].
Rotate [DIAL] until the “Perspective View” menu is
w
highlighted, then push [ENTER].
Rotate [DIAL] until the desired menu is highlighted,
e
then push [ENTER].
NOTE:
• While in the Perspective View function is ON, “TM”
(True Motion) cannot be used. (p. 2-5)
• While in the Radar Overlay function is ON, the Per -
spective View function cannot be used. (p. 2-36)
• Perspective View – Angle
(MENU w Chart Setup u Perspective View u Angle)
This item can be set only when the Perspective View
function is turned ON in the “Mode” item as above.
Rotate [DIAL] to adjust the Perspective View Angle
➥
to between 30º and 80º. (Default: 30º)
Rotate
When the Perspective View angle is 30º.
<Perspective View Mode menu>
<Perspective View Angle menu>
NOTE:
The Perspective View Angle can be adjusted
using the Quick menu, only when the Perspective View
function is turned ON in the “Mode” item as above.
Push [ENTER] to open Quick menu.
q
Push [
w
Ω] or [ ≈] to select the Perspective Angle
tab.
Rotate [DIAL] to adjust the Perspective View An-
e
gle to between 30º and 80º, then push [ENTER]
to set.
<Quick menu>