Icom IC-2710H, Instruction Manual, Page: 48 / 88

9
SCAN OPERATION
43
■
Programming scan edges
Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into pairs of
scan edge channels, 1A/1b to 3A/3b, in memory channels.
➀
Push the desired band’s tuning dial.
➁
Set the desired frequency in VFO mode:
➥
Push the selected band’s [V/MHz] to select VFO mode.
➥
Set the frequency using the selected band’s tuning dial.
➥
Set other data (e.g. offset frequency, etc.) if required.
➂
Push [S.MW] momentarily.
• “
!
” and the memory channel number flashes.
[EXAMPLE]: Programming 145.30 MHz and 145.80 MHz for the VHF scan edges 1A and 1b.
1 5 9 1 5 9
S.MW MW
Push
VHF
tuning
dial.
then rotate
Rotate
Push
momentarily
S.MW MW
S.MW MW
Push
and hold
continue pushing
Program 1b in the same manner.
➃
Rotate the tuning dial to select a scan edge channel (1A to
3A).
➄
Push [
(S.MW)
MW] for 1 sec. to program.
• 3 beeps may sound and the frequency is programmed.
• Scan edge 1b is automatically selected when continuing to push
[
(S.MW)
MW] after programming.
➅
To program a frequency for the other pair of scan edges,
1b to 3b, repeat steps
➃
and
➄
.
• If the same frequency is programmed into both scan edges, pro-
grammed scan will not function.
IC-2710H.qxd 02.2.8 16:55 Page 43 (1,1)