![background image](http://html.mh-extra.com/html/icom/i9100/i9100_instruction-manual_611948190.webp)
181
17
MAINTENANCE
■
Resetting the CPU
D
Partial reset
If you want to reset the operating parameters to their
default values (VFO frequency, VFO settings, menu
group’s contents) without clearing certain data as de-
scribed below, a partial reset can be performed.
The following data will not be cleared when doing a
Partial reset:
• Memory contents
• Call sign memories
• Repeater lists
• TX messages
• GPS memories
• GPS messages
• Memory keyer contents
• Programmed user band edge frequencies
• Programmed Auto Repeater frequency ranges
• REF Adj (Reference frequency) setting
q
First, turn OFF the transceiver power.
w
While holding down [F-INP ENT] and [VFO/MEMO],
push [POWER] to turn ON the power.
• During start-up, the transceiver displays “PARTIAL
RESET,” then its initial VFO frequencies when resetting
is complete.
• If you operate the transceiver before “PARTIAL RESET”
disappears, the resetting will be cancelled.
e
If desired, edit the Set mode settings after reset-
ting.
D
All reset
The display may occasionally display erroneous infor-
mation (e.g. when first applying power). This may be
caused externally by static electricity or by other fac-
tors.
If this problem occurs, turn OFF the power. After wait-
ing a few seconds, turn ON the power again. If the
problem persists, perform the following procedure.
NOTE:
Resetting the CPU CLEARS all programmed
contents and returns them to their default settings.
q
First, turn OFF the transceiver power.
w
While holding down [F-INP ENT] and [M-CLR],
push [POWER] to turn ON the power.
• During start-up, the transceiver displays “ALL CLEAR,”
then when resetting is complete, then displays the initial
VFO frequencies.
• If you operate the transceiver before “ALL CLEAR” dis
-
appears, the resetting will be cancelled.
e
After resetting, edit the Set mode settings, if de-
sired.
[POWER]
[F-INP ENT] [M-CLR]
[POWER]
[F-INP ENT]
[VFO/MEMO]