IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 60 / 257

3-16
TS2900 Tape Autoloader Setup, Operator, and Service Guide
Static library network settings must be entered using the Operator Panel before the
library can be accessed remotely using the Web User Interface. If your system is
serviced by a DHCP (Dynamic Host Configuration Protocol) server, the network
parameters will be automatically set. Once remote access has been established, you
can complete the configuration of your library remotely.
If you choose to use the Operator Panel to configure your library, go to “Configuring
Your Library using the Operator Panel” on page 3-28.
Configuring Your Library using the Web User Interface
If you choose to use the Web User Interface to configure your library, first enter your
library network settings using the Operator Panel (see “Configuring Network
Settings” on page 3-29).
To configure your library using the Web User Interface, complete the following
procedures:
1. Install Java 1.5.0 or higher on your host computer. Download the latest version of
the Java Runtime Environment (JRE) for your platform from
http://www.java.com/
.
2. “Logging in to the Web User Interface” on page 3-17
3. “Checking Firmware Level” on page 3-18
4. “Configuring Library Settings” on page 3-18
5. “Configuring Network Settings” on page 3-20
6. “Configuring Date and Time Settings” on page 3-21
7. “Configuring Encryption Settings” on page 3-22
8. “Configuring E-mail Notifications” on page 3-24
9. “Configuring Trap Notifications” on page 3-25
10. “Managing User Access” on page 3-27
11. “Saving the Library Configuration” on page 3-28
Advanced encryption settings (None)
D
ATE AND
T
IME
NTP server Disabled
NTP server address 0.0.0.0
Time zone (GMT) +00:00
Auto adjustment by PC Every 1 minute
N
OTIFICATIONS
SMTP (mail) settings
Mail server address 0.0.0.0
Mail event Error events enabled
SNMP (trap) settings
Community Public
Trap event Error events enabled
SNMPv3 engine ID (Set by library firmware)
Table 3-4. Default library configuration settings (continued)
Configuration Item Default Setting