IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 154 / 257

8-6
TS2900 Tape Autoloader Setup, Operator, and Service Guide
4. Attach the deskside cover using the 2 large pan-head screws on the rear of the
library (Figure 8-10).
Figure 8-10. Attaching the cover to the library chassis (rear screws)
5. Place the library in the desired desktop location.
Important: Do not place the library on its side. Do not stack objects on top of the
library.
6. Remove the Accessor locking screw .
Figure 8-11. Removing Accessor locking screw
7. On the rear panel of the library:
a. Connect the SAS host interface cable.
b. Connect the Ethernet cable.
c. Connect the power cable from the library power supply. Route all cables
through the hook and loop fastener strap.
d. Power ON the library by toggling the power supply switch to the ON (|)
position.
8. Insert the cartridge magazine if previously removed.
9. Restore the library configuration. See “Saving and Restoring Configuration
Settings” on page 4-28.
10. From the Operator Panel, select Run Library Verify , and press Enter to run
library diagnostics. Follow the on-screen instructions. If an error occurs, see
Chapter 6, “Troubleshooting,” on page 6-1.
11. Take the library online.
Important: Do not stack objects on top of the library.
For more detailed instructions, see Chapter 3, “Installation and Configuration,” on
page 3-1.
4
a29z0012
4
1
a29z0026
1