IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 198 / 257

B-6
TS2900 Tape Autoloader Setup, Operator, and Service Guide
008A
X calibration error #3.
During X-drive calibration,
centering sensor OFF
condition could not be
detected. Suspect the
centering sensor, X motor, or
P motor.
CHK 008A
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
008B
X calibration error #4.
During X-drive calibration,
centering sensor ON
condition could not be
detected. Suspect the
centering sensor, X motor, or
P motor.
CHK 008B
008F
During X operation, the
cartridge magazine was
removed. Suspect the
magazine set sensor.
CHK 008F
1. Confirm the magazine is closed.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
00B0
Failed to detect media in the
Accessor at completion of
GET operation. Suspect the
centering sensor, X motor, or
P motor.
CHK 00B0
1. Confirm the media is compatible.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
00B1
No media is contained in the
specified cell (Cell Empty).
Suspect the centering sensor,
X motor, or P motor.
CHK 00B1
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
00B2
Media detected in the
Accessor at completion of
centering check operation.
Suspect the centering sensor.
CHK 00B2
1. If the cartridge remains in the Accessor, try to
move the cartridge from the Accessor to the I/O
Station using the Operator Panel or Web User
Interface. Remove the cartridge from the library
and inspect for damage and replace, if
necessary.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
00B3
Media detected in the
Accessor at completion of
PUT operation. Suspect the
centering sensor.
CHK 00B3
00B8
Accessor error #1.
Reverse REV position (PP1)
error (Accessor origin not
detected or FWD position
detected). Suspect the P
origin sensor, FWD sensor, or
P motor.
CHK 00B8
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
Table B-1. Library error codes (continued)
Code (H) Description Panel Indication Action Required