IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 197 / 257

Appendix B. Error Codes
B-5
007D
Drive does not enter
MOUNT state within 200
seconds of a PUT command.
Suspect the drive or X motor.
CHK 007D
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
007E
Drive does not enter SET
state within 3 seconds of a
PUT command. Suspect the
drive or X motor.
CHK 007E
007F
Drive I/F or connection error
occurs during a PUT
operation or GET operation.
Suspect the drive.
CHK 007F
1. Reseat all cables. See “Reseating Cables” on
page 6-10.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
0080
X movement error #1.
During X movement, the
target stop position’s origin
sensor error detected.
Suspect the X origin sensor or
X motor.
CHK 0080
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
0081
X movement error #2.
During X movement, a motor
sync error detected. Suspect
the X encoder sensor or X
motor.
CHK 0081
0082
X movement error #3.
During initialization, a motor
sync error detected. Suspect
the X encoder sensor or X
motor.
CHK 0082
0083
During an eject operation or
move operation (to a storage
position), the X origin sensor
could not be detected.
Suspect the X origin sensor or
X motor.
CHK 0083
0084
During initialization, the X
origin position could not be
detected. Suspect the X origin
sensor or X motor.
CHK 0084
0088
X calibration error #1.
During X calibration,
centering sensor OFF
condition could not be
detected. Suspect the
centering sensor or X motor.
CHK 0088
0089
X calibration error #2.
During X calibration,
centering sensor ON
condition could not be
detected.
CHK 0089
Table B-1. Library error codes (continued)
Code (H) Description Panel Indication Action Required