IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 214 / 257

D-4
TS2900 Tape Autoloader Setup, Operator, and Service Guide
12–13 Additional Sense Code (ASC)
Additional Sense Code Qualifier (ASCQ)
Byte 12 Byte 13
ASC ASCQ
11 12 Auxiliary memory read error. The drive reported that it is unable to read the Auxiliary
Memory in a WORM cartridge.
14 00 Recorded Entity Not Found - A space or Locate command failed because a format
violation prevented the target from being found.
14 03 End Of Data not found - A Read type operation failed because a format violation related
to a missing EOD data set.
14 10 Not Ready - Auxiliary memory not accessible. The drive is not able to become ready
because it is unable to access the Auxiliary Memory in a WORM cartridge.
1A 00 Parameter list length error - The amount of parameter data sent is incorrect.
20 00 Invalid Command Operation Code - The Operation Code in the command was not a
valid Operation Code.
24 00 Invalid field in CDB - An invalid field has been detected in a Command Descriptor
Block.
25 00 LUN not supported - The command was addressed to a non-existent logical unit
number.
26 00 Invalid Field in Parameter List - An invalid field has been detected in the data sent
during the data phase.
27 00 Write Protect - A Write type operation has been requested on a cartridge which has been
write protected.
28 00 Not Ready to Ready Transition - A cartridge has been loaded successfully into the drive
and is now ready to be accessed.
29 00 Reset - The drive has powered on, received a reset signal or a bus device reset signal
since the initiator last accessed it.
2A 01 Mode Parameters Changed - The Mode parameters for the drive have been changed by
an initiator other than the one issuing the command.
30 00 Incompatible Media Installed - A write type operation could not be executed because it is
not supported on the cartridge type that is loaded.
30 01 Unknown Format - An operation could not be carried out because the cartridge in the
drive is of a format not supported by the drive.
30 02 Incompatible Format - An operation could not be completed because the Logical Format
is not correct.
30 03 Cleaning Cartridge Installed - An operation could not be carried out because the
cartridge in the drive is a cleaning cartridge.
30 07 Cleaning Failure - A cleaning operation was attempted, but could not be completed for
some reason.
30 0C Data Protect - WORM overwrite attempted. The drive rejected a write operation because
it would have resulted in an overwrite. Overwrite is not allowed on WORM media.
30 0D Medium Error - WORM integrity check. The drive rejected a Read or Write operation
because the cartridge is a suspicious WORM cartridge.
31 00 Media format corrupted - Data could not be read because the format on tape is not valid,
but is a known format. A failure occurred attempting to write the FID.
37 00 Rounded parameter - A Mode Select command parameter has been rounded because the
drive can not store it with the accuracy of the command.
3A 00 Media Not Present - A media access command has been received when there is no
cartridge loaded.
3B 00 Sequential Positioning Error - A command has failed and left the logical position at an
unexpected location.
3D 00 Invalid bits in identify Message - An illegal Identify Message has been received at the
drive at the start of a command.
3E 00 Logical Unit has not Self-Configured - The drive has just powered on and has not
completed its self test sequence and can not process commands.
Table D-3. Ultrium Tape drive sense data (continued)
Byte
Bit Address or Name
7 6 5 4 3 2 1 0