IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 194 / 257

B-2
TS2900 Tape Autoloader Setup, Operator, and Service Guide
0010
Information acquisition from
the DHCP server failed.
-
1. Observe LEDs. See “Interpreting Front Panel
LEDs” on page 6-8.
2. Confirm the DHCP server settings.
3. Reseat all cables. See “Reseating Cables” on
page 6-10.
4. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
0011
Time acquisition from the
NTP server failed.
-
1. Observe LEDs. See “Interpreting Front Panel
LEDs” on page 6-8.
2. Confirm the time server settings.
3. Reseat all cables. See “Reseating Cables” on
page 6-10.
4. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
0020
LDI I/F error.
Transmit data abnormality
detected (NAK reception).
-
1. Observe LEDs. See “Interpreting Front Panel
LEDs” on page 6-8.
2. Reseat all cables. See “Reseating Cables” on
page 6-10.
3. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
0021
LDI I/F error.
Receive timeout detected
(ACK/NAK reception).
-
0022
LDI I/F error.
Response packet reception
timeout detected.
-
0023
LDI I/F error.
ENQ receive timeout
detected.
-
0024
LDI I/F error.
Receive data abnormality
detected.
-
0029
Encryption command
terminates unsuccessfully.
-
1. Confirm the Encryption Key Manager settings.
2. Reseat all cables. See “Reseating Cables” on
page 6-10.
3. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
002A
Commands to the Encryption
Key Manager over the retry
limit.
-
002B
Commands to the encryption
capable drive over the retry
limit.
-
1. Reseat all cables. See “Reseating Cables” on
page 6-10.
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
Table B-1. Library error codes (continued)
Code (H) Description Panel Indication Action Required