IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 200 / 257

B-8
TS2900 Tape Autoloader Setup, Operator, and Service Guide
00D0
Checksum error detected
during firmware update.
CHK 00D0
1. Confirm the firmware file version.
2. Reinstall the firmware file.
3. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
00D1
Firmware ID error detected
during firmware update.
CHK 00D1
00D2
Boot information error
detected during firmware
update.
CHK 00D2
00D3
Bar code reader is not in
maintenance mode during
bar code reader firmware
update (operation
interrupted). Suspect the bar
code reader cable connection.
CHK 00D3
1. Initiate an inventory. See “Conducting a Library
Inventory” on page 4-6 (Operator Panel) or
“Conducting a Library Inventory” on page 4-19
(Web User Interface).
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
00D9
Magazine failed to unlock.
Suspect the magazine or
magazine sensor.
CHK 00D9
1. Cycle the power supply and try again.
2. Manually unlock the magazine, remove the
magazine from the library, and inspect it for
damage.
• If not damaged, return it to the library and
run Library Verify before resuming normal
library operations.
• If damaged, replace the magazine.
00DA
I/O Station failed to unlock.
Suspect the magazine or
magazine sensor.
CHK 00DA
00DD
An error detected during bar
code reader firmware check.
Suspect the bar code reader
cable connection.
CHK 00DD
1. Initiate an inventory. See “Conducting a Library
Inventory” on page 4-6 (Operator Panel) or
“Conducting a Library Inventory” on page 4-19
(Web User Interface).
2. Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
00E0
Write operation not finished
within 1 ms when writing
data to flash memory.
CHK 00E0
Cycle the power supply and try again.
• If the problem is corrected, run Library Verify
before resuming normal library operations.
• If the problem persists, see “Contacting IBM
Technical Support” on page 7-1.
00E1
Clear operation not finished
within 10 seconds when
clearing a sector in flash
memory.
CHK 00E1
00E2
Error detected in tape library
configuration stored in flash
memory.
CHK 00E2
00E3
Checksum error detected in
flash memory.
CHK 00E3
00F0
Sensor error #1.
Accessor encoder sensor B
error detected during blink
check. Suspect the Accessor
encoder sensor B.
CHK 00F0
Table B-1. Library error codes (continued)
Code (H) Description Panel Indication Action Required