IBM System Storage TS2900, Setup, Operator, And Service Manual

Page: 163 / 257

Chapter 8. Removal and Replacement Procedures
8-15
b. Contact IBM Technical Support for the service password.
In the USA: 1-800-IBM-SERV (1-800-426-7378)
All other countries and regions:
http://www.ibm.com/planetwide/ .
c. Log in to the Web User Interface. Use the username service and the
password from IBM Technical Support.
d. Go to Configure Library
→
Save/Restore . Enter the serial number to match
the serial number of your old library and click Restore Serial .
Figure 8-28. Save/Restore screen
e. On the same screen, click Restore to restore the saved configuration from
your old library to your new library. If you do not have a saved
configuration on your host, you must reconfigure your library. See
“Configuring the Library” on page 3-14.
f. Log out of the Web User Interface.
g. Log in to the Web User Interface as admin .
h. Verify all configuration settings. Change any settings as required. Update
the Library Configuration Form, if necessary. Save your new configuration
using the Web User Interface (
Configure Library
→
Save/Restore ).
i. Update your host application device table with the new drive serial
number. To determine the new drive serial number, log in to the Web User
Interface and refer to the drive information on the
Library Map .
5. After physically installing and reconfiguring the new library, confirm that the
library firmware installed is the latest version. Note the firmware revision
number using the
System Summary window of the Web User Interface and
check against the latest firmware version at http://www-03.ibm.com/servers/
storage/support . To update the library firmware, if necessary, see “Updating
Library and Drive Firmware” on page 4-34.
6. Copy the serial number and WWN from the old library onto the new library. This
step is necessary to maintain a valid warranty. See “Applying a RID Tag to a
Library” on page 8-16.
a29z0094