14
Ch.2 Using huperRemote
The PTZ Camera Control Panel
If there are PTZ cameras in any of the DVR sites, you can use the
PTZ Camera Control
Panel
to zoom in or out and pan around the monitored areas.
Click
to open the PTZ Camera Control Panel.
3. You can add a whole DVR site or only
selected cameras into the group:
• To add a whole DVR site, first make
sure that there is a check mark in its
check box (which means that all
cameras under this site are selected).
If there is no check mark, click the
check box. Then, drag and drop the
DVR site into the group.
• To add only certain cameras of a site
to the group, first select the desired
cameras. The check box on the
DVR site will then be marked with a
red box. Now drag and drop the
DVR site into the group.
• If you want to add only a single
camera from a site into the group,
select that camera then drag and
drop it into the group.
4. Repeat step 3 to add more DVR sites or
cameras into the group.
The number buttons are
Preset
buttons
that store different
camera angle positions. Click a
number button to quickly
adjust the PTZ camera to a
predefined position.
This is the
Zoom
control. Drag the
slider tab up to zoom in, or down to
zoom out.
When you release the mouse
button, the slider tab moves back to
the middle position automatically.
This is the
Pan and Tilt
control.
Click one of the four arrow
buttons to adjust the camera
angle up, down, left, or right.
Click the "cross" button to stop
movement.
Group of DVR sites
Group of cameras from multiple sites
Summary of Contents for huberDVR 2400
