Hughes HX100, Installation Manual

Page: 41 / 138

Chapter 3 • Installing the Hardware
1037106-0001 Revision B.03-Draft
23
3. The LAN LED lights up within 30 seconds, indicating that
LAN connectivity is detected.
4. The Power LED blinks, indicating that the unit is not
commissioned and therefore is running
fallback.bin
rather than
main.bin
Note: It is recommended that the remote terminal be protected
by a surge protector. Power surges are a common cause of failure
for electronic devices.
Note: In countries outside North America, the remote terminal
may be plugged directly into a 240V outlet with a replacement
power cord. Different countries may have different standards and
requirements.
%%THIS IS FROM THE HX100 MANUAL. IS
IT TRUE FOR THE HX50??%%
CAUTION
•
To remove power from a remote terminal, ALWAYS
unplug the AC power cord from the wall outlet, surge
protector, or power strip.
•
Remote terminals must be used with 110/240-volt AC
Input.
•
If the remote terminal is installed in any country outside
the United States and Canada, always observe the
power standards and requirements of that country.