Hughes HX100, Installation Manual

Page: 38 / 138

Chapter 3 • Installing the Hardware
20
1037106-0001 Revision B.03-Draft
Connecting component
cables
Using Figure 13 (HX50) or Figure 14 (HX100) as a reference,
perform the following procedures to connect the required
component cables.
1. Place the remote terminal in the desired installation location.
Connect the installer PC to the remote terminal with an Ethernet
cable. Ensure that no Ethernet routers or switches are currently
connected between the remote terminal and the customer’s
CAUTION
•
The two-way satellite dish must be installed in a
location or manner not readily accessible to children
and so that the dish bottom is at least 5 feet above
ground level.
•
This device emits radio frequency energy when in
transmit mode. Therefore, the Federal Communications
Commission requires professional installation and
service of the two-way satellite dish.
•
To avoid injury, do not place head or other body parts
between the feed horn and satellite dish when the
system is operational.
•
Unplug the indoor power connection before performing
maintenance or adding upgrades to any satellite dish
components.
•
Do not allow anything to come in contact with the front
surface of the satellite dish.
CAUTION
• Do not block any ventilation openings. Do not place the
remote terminal near heat sources such as radiators,
heat registers, ovens, stoves, or other apparatus
(including amplifiers) that produce heat.
• Leave 6 inches of space around the top and sides of the
terminal to ensure ventilation and prevent overheating.