Hughes HX100, Installation Manual

Page: 101 / 138

Chapter 7 • The System Control Center
1037106-0001 Revision B.03-Draft
83
22 The transmitter is disabled pending a transmit
pointing test This condition occurs when the transmitter is
unable to perform a periodic background
transmit pointing test within the allotted time
frame. The transmitter is expected to be in this
condition at random periodic intervals for no
more than two minutes at a time. This condition
can also occur after the transmitter is first
powered on after it has been powered off for
more than a 24 hours. If this condition persists
for more than two minutes, it is likely that the
automated transmit pointing components in the
HX GTWY are experiencing problems. This
condition should clear in a few minutes.
23 The transmitter is disabled because a transmit
pointing test cannot be performed This condition occurs when the transmitter
cannot perform a transmit pointing test during
initial installation or when ranging. Ranging is
the automated process of adjusting the satellite
transmitter timing and power. The satellite
transmitter performs ranging as necessary to
ensure that it can communicate successfully
with the HX GTWY. The condition indicates
that the GTWY components required to
perform the transmit pointing test are not
operational.
24 The transmit cable is disconnected This message is displayed if the HX unit
cannot detect the transmit cable connection.
Ensure that the transmit cable is securely
attached to the HX unit and to the transmitter
on the antenna assembly. Inspect the transmit
cable and the antenna assembly to make sure
that they are not damaged.
Table 5: Transmit code (TxCode) messages and corrective actions (Continued)
Code Message Corrective actions