Hughes HN9200, Installation Manual

Page: 85 / 132

Transmission Information page
The Transmission Information page shown in Figure 61: Transmission Information page on
page 73 displays information about data transmissions from the satellite modem.
Figure 61: Transmission Information page
The parameters listed on the Transmission Information page are explained in the following table.
Table 8: Transmission Information page parameters
Explanation Parameter
Indicates if the transmit data path is operational. Click the displayed
TxCode for explanation of the displayed code. Transmit Status
Number of frames transmitted to the satellite. Number of Successful Transmissions
Number of frames that could not be sent. A continuously increasing
value indicates a transmission problem. If a low value is displayed Number of Failed Transmissions
and does not increase, and the system is functioning, there is no
reason for concern.
Total number of data packets queued for transmission to the satellite
since the modem was last restarted. Number of Packets Submitted for
Transmission
Examining transmit status
You can check the Transmit Status parameter to find out if the transmission data path is
operational or if there is a problem. Normal transmit status is indicated by the message
Transmitter ready. (TxCode 8)
.
The following two illustrations show how you can view a list of all TxCodes or see an explanation
of the currently displayed TxCode. Each TxCode—except TxCode 8—indicates a specific
problem in the transmission path.
73
HN9200 Satellite Modem Installation Guide
1038622-0001 Revision B
Chapter 6 System Control Center