Hughes HN9200, Installation Manual

Page: 22 / 132

required antenna model on the Installation Reference Sheet; then locate the installation guide
for that model on your installation support web site.
When you install the antenna assembly, read and follow all safety
alerts and instructions in the antenna installation guide and in the
Antenna Site Preparation and
Mount Installation Guide
(1035678-0001).
IFL cables
Before you can install the satellite modem, you must route the coaxial IFL cables between the
indoor satellite modem location and the antenna. Then you connect the modem and the antenna
by connecting the IFL cable to both components.
The routing path of the IFL cables between the modem and the antenna depends on the building
configuration. Guidelines for installing IFL cables are included in the
Antenna Site Preparation
and Mount Installation Guide (1035678-0001).
Requirements for cables, connectors, and ground blocks
You must use approved cable types and connectors to connect the modem to the outdoor satellite
antenna. For grounding, you must use approved ground blocks and grounding connectors. For
detailed specifications and information on these components, see the documents listed in
Table
3: Related installation documents on page 11.
The coaxial IFL cables and the ground block to which they are connected must meet the grounding
requirements specified in the following warning:
You must comply with applicable local codes and the
grounding requirements in Field Service Bulletin (FSB),
HNS Broadband Requirements for
RG-6 and RG-11 IFL Cable Connectors, Ground Blocks, and Ground Block Location
(FSB_050518_01). Improper grounding can result in electric shock injury, property damage,
and/or poor modem performance.
Labeling the IFL cables
Label the receive and transmit IFL cables at the outdoor point-of-entry and at the indoor location
where the satellite modem is installed as follows:
• Wrap a piece of red electrical tape around the receive cable, and mark SAT IN on the tape.
• Wrap a piece of blue electrical tape around the transmit cable, and mark SAT OUT on the
tape.
Hub or similar network device
If the satellite modem is to be connected to a network, an Ethernet hub, modem, wireless base
station, or other similar device is required. The customer must supply and configure the network
device, including required cables, according to the device manufacturer’s documentation. Required
IP address information is obtained during modem commissioning.
HN9200 Satellite Modem Installation Guide
10
1038622-0001 Revision B
Preparing for installation Chapter 2