Hughes HN9200, Installation Manual

Page: 100 / 132

Confirming the receive signal
To confirm that the modem is properly receiving satellite signals:
1. At the System Control Center, click the
Reception Info
link.
The Reception Information page appears.
2. In the Receive Status field, check the RxCode.
If the RxCode is
Receiver operational (RxCode 5)
the modem is receiving signals properly;
proceed to Confirming the transmit signal on page 88.
If any other RxCode appears, the modem is not receiving signals properly. Click the RxCode,
and follow the troubleshooting procedure that appears. Click the RxCode for explanation of
the problem and/or troubleshooting information.
Figure 71: Reception Info page
Note: The RxCode shown is an example.
Confirming the transmit signal
To confirm that the modem is properly transmitting signals to the satellite:
1. At the System Control Center, click the Transmission Info link.
The Transmission Information page appears.
2.
In the
Transmit Status
field, check the TxCode.
If the TxCode is Transmitter Ready (RxCode 8) the modem is transmitting signals properly;
proceed to Confirming that TCP Acceleration is operational on page 89.
If any other TxCode appears, the modem is not transmitting signals properly. Click the
TxCode for explanation of the problem and/or troubleshooting information.
Figure 72: Transmission Info page
HN9200 Satellite Modem Installation Guide
88
1038622-0001 Revision B
Troubleshooting Chapter 8