HP Integrity rx7640, Service Manual

Page: 97 / 195

Primary Boot Path: 0/0/2/0/0.13
0/0/2/0/0.d (hex)
HA Alternate Boot Path: 0/0/2/0/0.14
0/0/2/0/0.e (hex)
Alternate Boot Path: 0/0/2/0/0.0
0/0/2/0/0.0 (hex)
Main Menu: Enter command or menu >
3. Boot the device by using the
BOOT
command from the BCH interface.
You can issue the
BOOT
command in any of the following ways:
•
BOOT
Issuing the
BOOT
command with no arguments boots the device at the primary (PRI)
boot path.
•
BOOT
bootvariable
This command boots the device indicated by the specified boot path, where bootvariable
is the PRI, HAA, or ALT boot path.
For example,
BOOT PRI
boots the primary boot path.
•
BOOT LAN INSTALL
or
BOOT LAN.
ip-address
INSTALL
The
BOOT... INSTALL
commands boot HP-UX from the default HP-UX install server
or from the server specified by ip-address.
•
BOOT
path
This command boots the device at the specified path. You can specify the path in HP-UX
hardware path notation (for example, 0/0/2/0/0.13) or in path label format (for example,
P0 or P1) .
If you specify the path in path label format, then path refers to a device path reported
by the last
SEARCH
command.
After you issue the
BOOT
command, the BCH interface prompts you to specify whether you
want to stop at the ISL prompt.
To boot the
/stand/vmunix
HP-UX kernel from the device without stopping at the ISL
prompt, enter
n
to automatically proceed past ISL and execute the contents of the
AUTO
file
on the chosen device. (By default the
AUTO
file is configured to load
/stand/vmunix
.)
Main Menu: Enter command or menu > BOOT PRI
Primary Boot Path: 0/0/1/0/0.15
Do you wish to stop at the ISL prompt prior to booting? (y/n) >> n
ISL booting hpux
Boot
: disk(0/0/1/0/0.15.0.0.0.0.0;0)/stand/vmunix
To boot an HP-UX kernel other than
/stand/vmunix
, or to boot HP-UX in single-user or
LVM-maintenance mode, stop at the ISL prompt and specify the appropriate arguments to
the
hpux
loader.
Booting and Shutting Down HP-UX 97