HP Integrity rx7640, Service Manual

Page: 53 / 195

Table 3-1 Wheel Kit Packing List (continued)
Quantity Description Part Number
1 Left front caster assembly A6753-04006
1 Left rear caster assembly A6753-04007
4 M4 x 0.7 8mm T15 steel zinc machine screw (Used to attach
each caster to the chassis) 0515-2478
1 Plywood unloading ramp A6093-44013
2 Phillips head wood screw (Used to attach the ramp to the
pallet) Not Applicable
Tools Required for Installation
The following list provides the installer with the recommended
tools to perform the wheel kit installation.
• Diagonal side cutters
• Safety glasses
• Torx screwdriver with T-15 bit
• Phillips head screwdriver
WARNING! Wear protective glasses while cutting the plastic bands around the shipping
container. These bands are under tension. When cut, they can spring back and cause serious eye
injury.
Use the following procedure to install the wheel kit.
1. Cut and remove the polystrap bands securing the HP server to the pallet.
2. Lift the carton top from the cardboard tray resting on the pallet.
3. Remove the bezel kit carton and the top cushions from the pallet.
Figure 3-10 Component Locations
Top Cushions
Cardboard
Tray
Bezel Kit
4. Unfold bottom cardboard tray.
5. Carefully tilt the server and place one of the foam blocks (A6093-44002) under the left side
of the server. Do not remove any other cushions until instructed to do so.
Wheel Kit Installation 53