HP Integrity rx7640, Service Manual

Page: 131 / 195

Table 5-7 Core I/O Buttons
Function Location Button Identification (as
silk-screened on the
bulkhead)
Resets the MP
NOTE:
If the MP RESET button is held for longer than five
seconds, it will clear the MP password and reset the LAN,
RS-232 (serial port), and modem port parameters to their
default values.
LAN Default Parameters
• IP Address—192.168.1.1
• Subnet mask—255.255.255.0
• Default gateway—192.168.1.1
• Hostname—gsp0
RS-232 (Serial Port) Default Parameters
• 9600 baud
• 8 bits
• No parity
Center of the core I/O card MP RESET
Request OL* for this core I/O slot
NOTE: The OLR function is not enabled for the core I/O card.
Top end of the core I/O card OLR (Symbol next to
button is shown below)
PCI-X Hot-Plug LED OL* LEDs
Table 5-8 OL* LED States
Attention (Yellow) Power (Green) State
Off On Normal operation, slot power on
Flashing On Slot selected, slot power on
On On Slot needs attention, slot power on
Off Off Slot available, slot power off
Flashing Off Ready for OL*, slot power off
On Off Fault detected, slot power off
Off Flashing Slot powering down or up
Disk Drive LEDs
There are two tri-color LED on each disk drive.
Server LED Indicators 131