HP 8924E, Assembly

Page: 162 / 640

162
Chapter 5, HP 8924C Performance Verification
RF Gen Duplex Output High Level Accuracy Performance Test 5
N:\mkt\MANUALS\HP8924C\ALR\24c_pt.fb
NOTE: Make sure to enter the power sensor’s calibration data into the measuring receiver and zero
the sensor module. Refer to the measuring receiver’s and the sensor module’s operating
manuals.
Procedure
1. Access the CONFIGURE screen.
2. Change the
RF Display
field to
Freq
.
3. Access the RF GENERATOR screen.
4. Set the
Output Port
field to
Dupl.
5. Set the
AFGEN1 TO
and
AFGEN2 To
fields to
Off (using the ON/OFF
key).
6. Measure the RF power at the frequencies and levels shown in the PTR ( see "RF Gen
Duplex Output High Level Accuracy Performance Test 5" on page 314 ) and
compare the measured RF power to the limits shown in the PTR.
AFGen2 Freq
AFGen2 To
RF Gen Freq
Amplitude
Atten Hold
Output Port
AFGen 1 Freq
AF Gen1 To
FM Coupling Audio Out
Mic Pre-Emp
Mod In To
To Screen
TX Frequency
TX Power
RF GENERATOR
AC Level
Level (dBm) RF Freq (MHz)
Select Off
Select Dupl