HP 8924E, Assembly

Page: 301 / 640

301
Chapter 6, HP 8924E Performance Verification
CDMA Analyzer Calibrated Tuned Channel Power Level Accuracy Performance Test 31
N:\mkt\MANUALS\HP8924C\ALR\24e_pt.fb
Measuring Receiver
Set the display mode to LOG.
Set the measurement to Tuned RF Level.
Calibrate the power sensor.
NOTE: The power sensor’s calibration data must be entered into the measuring receiver and the sensor
module must be zeroed. Refer to the measuring receiver’s and the sensor module’s operating
manual.
Measurement Procedure
1. Press the PRESET key on the Test Set.
2. Access the CONFIGURE screen.
3. Set the
RF Display
field to
Freq
.
4. Set the
(GEN)-(ANL)
field to
0 MHz
.
5. Change
Output Port
to
Duplex Out
.
6. Set the
Input Atten
field to
Hold
and
0 dB
.
7. Access CDMA Call Control Screen.
8. Set the
RF Gen Freq
field to
840 MHz
.
9. Measure each of the RF levels in the PTR with the Test Set and the measuring
receiver ( see "CDMA Analyzer Calibrated Tuned Channel Power Level Accuracy
Performance Test 31" on page 403 ) and record the results.