HP 8924E, Assembly

Page: 166 / 640

166
Chapter 5, HP 8924C Performance Verification
RF Gen RF IN/OUT Level Accuracy Performance Test 7
N:\mkt\MANUALS\HP8924C\ALR\24c_pt.fb
NOTE: Make sure to enter the power sensor’s calibration data into the measuring receiver, and zero
the power sensor. Refer to the measuring receiver’s operating manual. The procedure for
making tuned RF Level measurements is also in the measuring receiver’s manual.
Procedure
1. Access the CONFIGURE screen.
2. Change the
RF Display
field to
Freq
.
3. Select the RF GENERATOR screen.
4. Set the
Output Port
field to
RF Out.
5. Set the
AFGen1 To
and
AFGen2 To
fields to
Off.
6. Measure the RF Level at the frequencies and levels shown in the PTR ( see "RF Gen
RF IN/OUT Level Accuracy Performance Test 7" on page 319 ) and compare the
measured RF level to the limits shown in the PTR.
AFGen2 Freq
AFGen2 To
RF Gen Freq
Amplitude
Atten Hold
Output Port
AFGen 1 Freq
AF Gen1 To
FM Coupling Audio Out
Mic Pre-Emp
Mod In To
To Screen
TX Frequency
TX Power
RF GENERATOR
AC Level
Level (dBm)
RF Freq (MHz)
Select Off
Select RF Out