Section 5 – Programming
5–17
Table 5–6: Initialization String Characters
Character Description
0-9
Numeric characters, which can be entered from the
touchpad or up/down arrows.
a-z and A-Z
Alpha characters entered with the up/down arrows.
: _ - . , & * # ?
E
C and space bar.
Special Characters entered with the up/down arrows.
1. Press
ENTER
MENU
at the flashing <Init Str> field.
2. Press
the
or
button until the desired character flashes.
3. Press
, the next character position will flash.
4. Repeat steps 2 and 3 until the desired sequence is complete.
5. Press
ENTER
MENU
.
6. Repeat steps 2 through 5 for the second string.
To clear an init string:
1. At
the
Clear String=N
field, press
until the desired option flashes. See Figure 5–7.
2. Press
ENTER
MENU
.
3. Press
to exit menu.
5.4.3.5 How to Set Automation Communication
Through this option the automation communication format and parameters can be set up. (See Table 5–5 for
format choices.)
Note:
After the automation format has been defined or changed, the output may not be correct until the
receiver has been reset.
How to Set the Format
Follow these steps to set the automation communication format.
1. Enter program mode. (See Section 5.1.)
2. Press
1
for general options.
3. Press
3
for communications.
4. Press
5
to setup automation configuration.
5. Press
the
or
button until the display flashes on the desired port setting.
6. Press
ENTER
MENU
.
7. Press
if you wish to exit menu or continue with heartbeat.
