MX8000 Installation and Operation Guide
5–66
3. Press
until the display flashes on the
BillDly
field.
4. Press
the
or
button to toggle the billing delay between “Yes” or “No”.
5. When the desired setting is flashing press
ENTER
MENU
.
To Change the Hunt Group:
Note:
If a Hunt Group number is assigned to a line that has a virtual line number assigned, the Hunt
Group Number will take precedence and the virtual line and receiver numbers will be ignored.
1. Follow the procedures in Section 5.5.4.
2. Press
5
for Miscellaneous Line Options menu.
3. Press
until the display flashes on the
HntGrp
field.
4. Enter the desired value from the keypad or press the
or
button to change the hunt group
number.
Notes:
•
If using the ADEMCO 685 Automation Protocol, valid entries are 00 through 08.
•
If using the CP-220 Automation Protocol, valid entries are 00 through 09 or 66 (B) through 70 (F).
Keypad entries for B through F are provided in Table 5–10 on page 5–23.
5. When the desired hunt group is flashing press
ENTER
MENU
.
6. To
exit
press
.
To Change the Call Hang-Up Time:
Notes:
•
If the Event Release setting (see page 5–26) is "greater" than the Call Hang-Up setting, the receiver will
not disconnect the line (panel) until the Event Release time has expired.
•
The actual amount of time before the receiver disconnects a line may at times be greater than the
actual programmed value for C Hang-Up Time. An event in progress (Event Release) has to complete
before the call hang-up takes affect.
1. Follow the procedures in Section 5.5.2.
2. Press
5
for Miscellaneous Line Options menu.
3. Press
until the display flashes on the
HngUp
field.
4. Enter the desired value from the keypad or press the
or
button to change the number of
seconds.
5. When the desired number of seconds is flashing press
ENTER
MENU
.
6. To
exit
press
.
